El Plato Loco

No violations were recorded at this inspection.

1. Aug 20, 2025 A 12 points (A range)

   Cycle Inspection · Initial Inspection

   1 critical1 general Show violations

   • CriticalFood temperature

     Hot food was being held below 140°F, where bacteria can grow.

     Official wording (code 02B)

     Hot TCS food item not held at or above 140 °F.

   • GeneralFacility upkeep

     Plumbing was missing protection against backflow, or floors didn’t drain properly.

     Official wording (code 10B)

     Anti-siphonage or back-flow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly. Condensation or liquid waste improperly disposed of.

2. Nov 15, 2023 –

   Administrative Miscellaneous · Initial Inspection · Violations were cited in the following area(s)

   1 paperwork Show violations

   • PaperworkSigns & paperwork

     Food Protection Certificate wasn’t available for the inspector.

     Official wording (code 18-11)

     Food Protection Certificate not available for inspection

3. Nov 15, 2023 16 16 points (B range)

   Pre-permit (Operational) · Initial Inspection

   Scored in the B range on an initial inspection, so no grade is given yet. A re-inspection follows.

   2 critical2 general Show violations

   • CriticalFood handling

     No working thermometer was available to check food temperatures.

     Official wording (code 04J)

     Properly scaled and calibrated thermometer or thermocouple not provided or not readily accessible in food preparation and hot/cold holding areas to measure temperatures of TCS foods during cooking, cooling, reheating, and holding.

   • CriticalFood temperature

     Hot food was being held below 140°F, where bacteria can grow.

     Official wording (code 02B)

     Hot TCS food item not held at or above 140 °F.

   • GeneralFacility upkeep

     Fridges or hot-holding units lacked an accurate thermometer.

     Official wording (code 10E)

     Accurate thermometer not provided or properly located in refrigerated, cold storage or hot holding equipment

   • GeneralFacility upkeep

     Plumbing was missing protection against backflow, or floors didn’t drain properly.

     Official wording (code 10B)

     Anti-siphonage or back-flow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly. Condensation or liquid waste improperly disposed of.