Don Pollo

No violations were recorded at this inspection.

1. Oct 22, 2025 B 17 points (B range)

   Cycle Inspection · Re-inspection

   2 critical2 general Show violations

   • CriticalPests

     Mice, or signs of mice, were found.

     Official wording (code 04L)

     Evidence of mice or live mice in establishment's food or non-food areas.

   • CriticalHygiene & sanitation

     Surfaces that touch food weren’t properly washed and sanitized.

     Official wording (code 06D)

     Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.

   • GeneralFacility upkeep

     Ventilation was missing or broken, letting grease, heat, or fumes build up.

     Official wording (code 10D)

     Mechanical or natural ventilation not provided, inadequate, improperly installed, in disrepair or fails to prevent and control excessive build-up of grease, heat, steam condensation, vapors, odors, smoke or fumes.

   • GeneralPests

     The building wasn’t pest-proofed: gaps, holes, or clutter that let rodents or insects in or give them shelter.

     Official wording (code 08A)

     Establishment is not free of harborage or conditions conducive to rodents, insects or other pests.

2. Aug 29, 2025 24 24 points (B range)

   Cycle Inspection · Initial Inspection

   Scored in the B range on an initial inspection, so no grade is given yet. A re-inspection follows.

   3 critical1 general Show violations

   • CriticalFood temperature

     Cold food was kept warmer than 41°F, where bacteria can grow.

     Official wording (code 02G)

     Cold TCS food item held above 41 °F; smoked or processed fish held above 38 °F; intact raw eggs held above 45 °F; or reduced oxygen packaged (ROP) TCS foods held above required temperatures except during active necessary preparation.

   • CriticalFood temperature

     Cooked food wasn’t cooled down quickly enough.

     Official wording (code 02H)

     After cooking or removal from hot holding, TCS food not cooled by an approved method whereby the internal temperature is reduced from 140 °F to 70 °F or less within 2 hours, and from 70 °F to 41 °F or less within 4 additional hours.

   • CriticalHygiene & sanitation

     Surfaces that touch food weren’t properly washed and sanitized.

     Official wording (code 06D)

     Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.

3. Feb 15, 2024 A 4 points (A range)

   Cycle Inspection · Re-inspection

   1 general1 paperwork Show violations

   • GeneralFacility upkeep

     Plumbing was missing protection against backflow, or floors didn’t drain properly.

     Official wording (code 10B)

     Anti-siphonage or back-flow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly. Condensation or liquid waste improperly disposed of.

   • PaperworkFood handling

     No “wash hands” sign at the hand sink.

     Official wording (code 09E)

     Wash hands sign not posted near or above hand washing sink.