Juquila

No violations were recorded at this inspection.

1. May 21, 2025 A 13 points (A range)

   Cycle Inspection · Initial Inspection

   2 critical1 general Show violations

   • CriticalHygiene & sanitation

     Clean utensils or equipment were stored or handled in a way that could contaminate them.

     Official wording (code 06E)

     Sanitized equipment or utensil, including in-use food dispensing utensil, improperly used or stored.

   • CriticalHygiene & sanitation

     Food or supplies weren’t protected from contamination during storage, prep, or service.

     Official wording (code 06C)

     Food, supplies, or equipment not protected from potential source of contamination during storage, preparation, transportation, display, service or from customer’s refillable, reusable container. Condiments not in single-service containers or dispensed directly by the vendor.

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.

2. Dec 12, 2023 A 13 points (A range)

   Cycle Inspection · Initial Inspection

   1 critical2 general Show violations

   • CriticalFood temperature

     Cooked food wasn’t cooled down quickly enough.

     Official wording (code 02H)

     After cooking or removal from hot holding, TCS food not cooled by an approved method whereby the internal temperature is reduced from 140 °F to 70 °F or less within 2 hours, and from 70 °F to 41 °F or less within 4 additional hours.

   • GeneralFood handling

     Food-contact surfaces were in poor repair.

     Official wording (code 09C)

     Design, construction, materials used or maintenance of food contact surface improper. Surface not easily cleanable, sanitized and maintained.

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.