Mango Mango

No violations were recorded at this inspection.

1. Jul 21, 2026 B 20 points (B range)

   Cycle Inspection · Re-inspection

   2 critical2 general Show violations

   • CriticalPests

     Flies or other nuisance pests were found.

     Official wording (code 04N)

     Filth flies or food/refuse/sewage associated with (FRSA) flies or other nuisance pests in establishment’s food and/or non-food areas. FRSA flies include house flies, blow flies, bottle flies, flesh flies, drain flies, Phorid flies and fruit flies.

   • CriticalFood handling

     Food was contaminated or cross-contaminated, or wasn’t thrown out when it should have been.

     Official wording (code 04H)

     Raw, cooked or prepared food is adulterated, contaminated, cross-contaminated, or not discarded in accordance with HACCP plan.

   • GeneralFacility upkeep

     Plumbing was missing protection against backflow, or floors didn’t drain properly.

     Official wording (code 10B)

     Anti-siphonage or back-flow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly. Condensation or liquid waste improperly disposed of.

   • GeneralPests

     The building wasn’t pest-proofed: gaps, holes, or clutter that let rodents or insects in or give them shelter.

     Official wording (code 08A)

     Establishment is not free of harborage or conditions conducive to rodents, insects or other pests.

2. May 28, 2026 45 45 points (C range)

   Cycle Inspection · Initial Inspection

   Scored in the C range on an initial inspection, so no grade is given yet. A re-inspection follows.

   6 critical1 general Show violations

   • CriticalHygiene & sanitation

     Wiping cloths were dirty or not kept in sanitizing solution.

     Official wording (code 06F)

     Wiping cloths not stored clean and dry, or in a sanitizing solution, between uses.

   • CriticalFacility

     A hand-washing sink was missing, blocked, or not stocked with soap and towels.

     Official wording (code 05D)

     No hand washing facility in or adjacent to toilet room or within 25 feet of a food preparation, food service or ware washing area. Hand washing facility not accessible, obstructed or used for non-hand washing purposes. No hot and cold running water or water at inadequate pressure. No soap or acceptable hand-drying device.

   • CriticalFood handling

     No one supervising the kitchen held a Food Protection Certificate.

     Official wording (code 04A)

     Food Protection Certificate (FPC) not held by manager or supervisor of food operations.

   • CriticalFood handling

     No working thermometer was available to check food temperatures.

     Official wording (code 04J)

     Properly scaled and calibrated thermometer or thermocouple not provided or not readily accessible in food preparation and hot/cold holding areas to measure temperatures of TCS foods during cooking, cooling, reheating, and holding.

   • CriticalHygiene & sanitation

     Surfaces that touch food weren’t properly washed and sanitized.

     Official wording (code 06D)

     Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.

   • CriticalFood handling

     Food was contaminated or cross-contaminated, or wasn’t thrown out when it should have been.

     Official wording (code 04H)

     Raw, cooked or prepared food is adulterated, contaminated, cross-contaminated, or not discarded in accordance with HACCP plan.

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.

3. Nov 25, 2025 A 13 points (A range)

   Cycle Inspection · Re-inspection

   1 critical1 general Show violations

   • CriticalFood handling

     No one supervising the kitchen held a Food Protection Certificate.

     Official wording (code 04A)

     Food Protection Certificate (FPC) not held by manager or supervisor of food operations.

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.

4. Jul 14, 2025 26 26 points (B range)

   Cycle Inspection · Initial Inspection

   Scored in the B range on an initial inspection, so no grade is given yet. A re-inspection follows.

   2 critical4 general Show violations

   • CriticalPests

     Flies or other nuisance pests were found.

     Official wording (code 04N)

     Filth flies or food/refuse/sewage associated with (FRSA) flies or other nuisance pests in establishment’s food and/or non-food areas. FRSA flies include house flies, blow flies, bottle flies, flesh flies, drain flies, Phorid flies and fruit flies.

   • CriticalHygiene & sanitation

     Surfaces that touch food weren’t properly washed and sanitized.

     Official wording (code 06D)

     Food contact surface not properly washed, rinsed and sanitized after each use and following any activity when contamination may have occurred.

   • GeneralFacility upkeep

     Fridges or hot-holding units lacked an accurate thermometer.

     Official wording (code 10E)

     Accurate thermometer not provided or properly located in refrigerated, cold storage or hot holding equipment

   • GeneralPests

     The building wasn’t pest-proofed: gaps, holes, or clutter that let rodents or insects in or give them shelter.

     Official wording (code 08A)

     Establishment is not free of harborage or conditions conducive to rodents, insects or other pests.

   • GeneralFacility upkeep

     Ventilation was missing or broken, letting grease, heat, or fumes build up.

     Official wording (code 10D)

     Mechanical or natural ventilation not provided, inadequate, improperly installed, in disrepair or fails to prevent and control excessive build-up of grease, heat, steam condensation, vapors, odors, smoke or fumes.

   • GeneralFacility upkeep

     Plumbing was missing protection against backflow, or floors didn’t drain properly.

     Official wording (code 10B)

     Anti-siphonage or back-flow prevention device not provided where required; equipment or floor not properly drained; sewage disposal system in disrepair or not functioning properly. Condensation or liquid waste improperly disposed of.