Parm

No violations were recorded at this inspection.

1. Nov 13, 2025 A 8 points (A range)

   Cycle Inspection · Re-inspection

   2 general Show violations

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.

   • GeneralFacility upkeep

     Single-use items (cups, utensils, containers) were missing, reused, or left unprotected.

     Official wording (code 10H)

     Single service article not provided. Single service article reused or not protected from contamination when transported, stored, dispensed. Drinking straws not completely enclosed in wrapper or dispensed from a sanitary device.

2. Aug 12, 2025 27 27 points (B range)

   Cycle Inspection · Initial Inspection

   Scored in the B range on an initial inspection, so no grade is given yet. A re-inspection follows.

   4 critical1 general Show violations

   • CriticalHygiene & sanitation

     Someone was eating, drinking, or smoking in a food prep or dishwashing area.

     Official wording (code 06B)

     Tobacco or electronic cigarette use, eating, or drinking from open container in food preparation, food storage or dishwashing area.

   • CriticalHygiene & sanitation

     Clean utensils or equipment were stored or handled in a way that could contaminate them.

     Official wording (code 06E)

     Sanitized equipment or utensil, including in-use food dispensing utensil, improperly used or stored.

   • CriticalFood temperature

     Cooked food wasn’t cooled down quickly enough.

     Official wording (code 02H)

     After cooking or removal from hot holding, TCS food not cooled by an approved method whereby the internal temperature is reduced from 140 °F to 70 °F or less within 2 hours, and from 70 °F to 41 °F or less within 4 additional hours.

   • CriticalHygiene & sanitation

     Workers’ personal hygiene was inadequate (dirty clothing, no hair restraint, jewelry).

     Official wording (code 06A)

     Personal cleanliness is inadequate. Outer garment soiled with possible contaminant. Effective hair restraint not worn where required. Jewelry worn on hands or arms. Fingernail polish worn or fingernails not kept clean and trimmed.

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.

3. Oct 3, 2023 A 6 points (A range)

   Cycle Inspection · Initial Inspection

   2 general Show violations

   • GeneralPests

     Garbage bins were not pest-proof or not kept covered and clean.

     Official wording (code 08B)

     Garbage receptacle not pest or water resistant, with tight-fitting lids, and covered except while in active use. Garbage receptacle and cover not cleaned after emptying and prior to reuse. Garbage, refuse and other solid and liquid waste not collected, stored, removed and disposed of so as to prevent a nuisance.

   • GeneralFacility upkeep

     Non-food surfaces or equipment were dirty, damaged, or made of unsuitable material.

     Official wording (code 10F)

     Non-food contact surface or equipment made of unacceptable material, not kept clean, or not properly sealed, raised, spaced or movable to allow accessibility for cleaning on all sides, above and underneath the unit.